D-Link EBR-2310 - Installation; Installation Location; Network Settings

11D-Link EBR-2310 User Manual
Section 2 - Installation
Installation
Installation Location
The EBR-2310 can be positioned at any convenient place in your oce or house. No special wiring or cooling requirements are needed. However,
you should comply with the following guidelines:
• Place the EBR-2310 on a at horizontal plane.
• Keep away from any heating devices.
• Do not place in a dusty or wet environment.
The recommended operational specications of the EBR-2310 are:
Temperature 32
°
F ~ 131°F
Humidity 5 % ~ 90 %
In addition, remember to turn o the power, remove the power cord from the outlet, and keep your hands dry when you install the hardware.
Network Settings
To use the EBR-2310 correctly, you have to properly congure the network settings of your computers. The default IP address of the EBR-2310 is 192.168.0.1,
and the default subnet mask is 255.255.255.0. These addresses can be changed as needed, but the default values are used in this manual. If the TCP/IP
environment of your computer has not yet been congured, you can refer to Conguring Your PCs to Connect to the EBR-2310 to congure it.
For example:
1. Congure your computer IP as 192.168.0.3, subnet mask as 255.255.255.0 and gateway as 192.168.0.1
Or more conveniently
2. Configure your computers to obtain TCP/IP settings automatically from the DHCP server feature of the EBR-2310
Since the IP address of the EBR-2310 is 192.168.0.1, the IP address of your computer must be 192.168.0.X (where “X” is a number between 2 and 254). Each
computer on your network must have a dierent IP address within that range. The default gateway must be 192.168.0.1 (the IP address of the EBR-2310).