61D-Link DIR-X4860 User Manual
Section 3 - Conguration
5GHz - Advanced Settings...
Security Mode Choose None or WPA/WPA2-Personal (recommended).
802.11 Mode (5GHz) Select the desired wireless networking standards to use.
The available options for the 5 GHz wireless network are Mixed
802.11a/n/ac/ax, Mixed 802.11a/n/ac, Mixed 802.11n/ac,
Mixed 802.11a/n, 802.11ac only, Mixed 802.11a only, or
802.11n only.
Wi-Fi Channel Select the desired channel. The default is Auto (recommended).
DFS Channel DFS enables you to use more channels to help nd one with
the least interference. However, please note that when using
DFS, the router must scan for radar signals for a minute before
using a channel, and will change channels automatically if
radar signals are detected.
Transmission Power Select the desired wireless transmission power.
Channel Width (5GHz) Select Auto 20/40/80 if you are using 802.11ac, 802.11n, and
802.11a devices, select Auto 20/40 if you are using 802.11n
and 802.11a devices, or select 20 MHz if you are using 802.11a
devices.
Visibility Status The default setting is Visible. Select Invisible if you do not
want to broadcast the SSID of your wireless network.
Schedule Use the drop-down menu to select the time schedule that
the rule will be enabled for. The schedule may be set to
Always Enable, or you can create your own schedules in the
Schedules section. Refer to Time & Schedule - Schedule on
page 85 for more information.
To Next Page
Loading...
Need help?
General
