D-Link GO-PL-200 - Hardware Installation; Power Connection; Ethernet Cable Connection; Power Saving Mode

8D-Link GO-PL-200/GO-PLK-200 User Manual
Section 2 - Installation
Hardware Installation
Power
Plug in the GO-PL-200 into an AC wall outlet. Note that it is not recommended to connect the GO-PL-200 to a power
strip or UPS.
Note: Power source is conrmed when the Power LED on the GO-PL-200 is illuminated.
Connect the Ethernet Cable
Connect the included Ethernet cable to the Ethernet port
located on the GO-PL-200 and attach the other end of the
Ethernet cable to your PC or Ethernet device. Network
Connectivity is conrmed when the Ethernet LED on the
GO-PL-200 is illuminated.
Power Saving Mode Enabled
When the Ethernet link activity has been down for 5
minutes, the GO-PL-200 will automatically go into power
saving mode. The Power LED will blink intermittently.
WARNING! D-Link powerline devices cannot be congured while in
Power Saving Mode.
1
ROOM C
GO-PL-200
PC
2
ROOM A ROOM B ROOM C
GO-PL-200GO-PL-200
RouterInternet
PC
GO-PL-200
PC
EXISTING PLC NETWORK