D-Link mydlink DSP-W215 Quick Install Guide

Hardware Overview
Power LED
Status LED
Outlet
WPS/Reset Button
ON/OFF Button
Front View
WPS/Reset Button
WPS
Press for one second to start the WPS
connection process. The Status LED will start
to blink green.
Reset
Press and hold until the Status LED turns
red in order to reset the device back to
the factory default settings (for about 10
seconds).
ON/OFF Button Press to turn the device connected to the DSP-W215 ON or OFF.
Status LED
Solid Green
The Smart Plug is successfully connected to
your network.
Blinking Green The WPS process is in progress.
Blinking Orange
The Smart Plug is not properly connected
with your wireless network.
Solid Red
The Smart Plug is powering on, attempting
to reset, or the device is defective.
O
If the Smart Plug will not power on, try
plugging the Smart Plug into another outlet.
Power LED
Solid Green
The electronic device you plugged into your
Smart Plug is powered on.
O
The device you plugged into your Smart Plug
is turned o or not receiving power.
Outlet
Connect your appliances, lamps, and other electronic devices you
wish to monitor.
4

D-Link mydlink DSP-W215 Specifications

Power

input voltage	100 to 240 V
power consumption	Maximum 5 W

Operating Environment

operating temperature	0 to 40 °C (32 to 104 °F)
storage temperature	-20 to 65 °C (-4 to 149 °F)
operating humidity	10% to 90% non-condensing
storage humidity	5% to 95% non-condensing

Weight and Dimensions

dimensions	117 x 66 x 39 mm (4.6 x 2.6 x 1.55 inches)
weight	125 grams (4.41 ounces)