xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show 802.1x auth_configuration
MAC address or by port.
Authentication Protocol: Radius_Eap/Local − Shows the authentication
protocol suite in use between the Switch and a RADIUS server.
Port number − Shows the physical port number on the Switch.
Capability: Authenticator|None − Shows the capability of 802.1x functions
on the port number displayed above. There are two 802.1x capabilities
that can be set on the Switch: Authenticator and None.
AdminCtlDir: Both / In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving and
transmitting directions, or just the receiving direction.
OpenCtlDir: Both / In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving and
transmitting directions, or just the receiving direction.
Port Control: ForceAuth / ForceUnauth / Auto − Shows the administrative
control over the port’s authorization status. ForceAuth forces the
Authenticator of the port to become Authorized. ForceUnauth forces the
port to become Unauthorized.
QuietPeriod − Shows the time interval between authentication failure and
the start of a new authentication attempt.
TxPeriod − Shows the time to wait for a response from a supplicant
(user) to send EAP Request / Identiy packets.
SuppTimeout − Shows the time to wait for a response from a supplicant
(user) for all EAP packets, except for the Request / Identity packets.
ServerTimeout − Shows the length of time to wait for a response from a
Radius server.
MaxReq − Shows the maximum number of times to retry sending packets
to the supplicant.
ReAuthPeriod − Shows the time interval between successive re-
authentications.
ReAuthenticate: Enabled / Disabled − Shows whether or not to re-
authenticate.
Restrictions None.
Example usage:
To display the 802.1x authentication states:
DGS-3400:4#show 802.1x auth_configuration ports 1
Command: show 802.1x auth_configuration ports 1
802.1X : Enabled
Authentication Mode : Port_based
Authentication Protocol : Radius_Eap
Port number : 1
Capability : None
AdminCrlDir : Both
OpenCrlDir : Both
Port Control : Auto
QuietPeriod : 60 sec
TxPeriod : 30 sec
SuppTimeout : 30 sec
ServerTimeout : 30 sec
MaxReq : 2 times
ReAuthPeriod : 3600 sec
ReAuthenticate : Disabled
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
138
To Next Page
Loading...
