D-Link xStack DGS-3426 - Network Management (Snmp) Commands

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
7
NETWORK MANAGEMENT (SNMP) COMMANDS
The network management commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
The DGS-3400 Series supports the Simple Network Management Protocol (SNMP) versions 1, 2c, and 3. After enabling SNMP,
you can specify which version of SNMP you want to use to monitor and control the Switch. three versions of SNMP vary in the
level of security provided between the management station and the network device. The following table lists the security features
of the three SNMP versions:
SNMP
Version
Authentication
Method
Description
v1 Community String
Community String is used for authentication −
NoAuthNoPriv
v2c Community String
Community String is used for authentication −
NoAuthNoPriv
v3 Username
Username is used for authentication −
NoAuthNoPriv
v3 MD5 or SHA Authentication is based on the HMAC-MD5 or
HMAC-SHA algorithms − AuthNoPriv
v3 MD5 DES or SHA DES Authentication is based on the HMAC-MD5 or
HMAC-SHA algorithms − AuthPriv.
DES 56-bit encryption is added based on the
CBC-DES (DES-56) standard
Command Parameters
create snmp user <username 32> <groupname 32> {encrypted [by_password auth [md5
<auth_password 8-16 > | sha <auth_password 8-20 >] priv [none | des
<priv_password 8-16>] | by_key auth [md5 <auth_key 32-32>| sha
<auth_key 40-40>] priv [none | des <priv_key 32-32>]]}
delete snmp user <username 32>
show snmp user
create snmp view <view_name 32> <oid> view_type [included | excluded]
delete snmp view <view_name 32> [all | oid]
show snmp view <view_name 32>
create snmp community <community_string 32> view <view_name 32> [read_only | read_write]
delete snmp community <community_string 32>
show snmp community <community_string 32>
config snmp engineID <snmp_engineID 10-64>
show snmp engineID
create snmp group <groupname 32> {v1 | v2c | v3 [noauth_nopriv | auth_nopriv | auth_priv ]}
{read_view <view_name 32> | write_view <view_name 32> | notify_view
<view_name 32>}
delete snmp group <groupname 32>
show snmp groups
27