Need help?Do you have a question about the D-Link xStack and is the answer not in the manual?
Configures the switch's IP address, subnet mask, and default gateway.
Configures IPv4 and IPv6 interfaces, including IP addresses and subnet masks.
Configures switch ports, including state, flow control, and speed/duplex settings.
Manages security features like 802.1X, MAC-based access control, and access profiles.
Manages Virtual Local Area Networks, including 802.1Q, port-based, and protocol VLANs.
Configures Spanning Tree Protocol (STP, RSTP, MSTP) to prevent network loops.
Controls IGMP snooping behavior to optimize multicast traffic forwarding.
Configures Link Layer Discovery Protocol (LLDP) for network topology discovery.
Manages bandwidth allocation and limits for ports to optimize traffic.
Configures the scheduling mechanism for hardware queues to prioritize traffic.
Assigns a default 802.1p priority to each port for traffic prioritization.
Establishes criteria for forwarding packets based on header information.
Configures flow metering and packet coloring based on traffic rates.
Filters packets destined for the CPU interface to enhance security.
Prevents unauthorized devices by locking MAC addresses to ports.
Restricts client access by binding MAC, IP, and port information.
Implements port-based or host-based access control for network security.
Configures web-based authentication and access control for users.
Displays the status of physical attributes like power supplies and fans.
Provides information about switches in a stack, including box ID and MAC addresses.
Displays CPU usage percentage as an average by time interval.
Shows packet statistics, including received, transmitted, and error counts.
Resets the switch to factory defaults, with options to retain certain configurations.
Restarts the switch to apply configuration changes or recover from issues.
Manages saving configurations to the switch's memory (RAM and NV-RAM).
Details how to use Packet Content ACL to prevent ARP spoofing attacks.
Lists and explains entries found in the system log.
Lists trap logs found on the DGS-3400 Series Switches.
Provides definitions of technical terms used in the manual.
To Next Page
General