xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
35
Parameter Description
System Severity
Choose how the alerts are used from the drop-down menu. Select log to send the alert of the
Severity Type configured to the Switch’s log for analysis. Choose trap to send it to an SNMP
agent for analysis, or select all to send the chosen alert type to an SNMP agent and the
Switch’s log for analysis.
Severity Level
Choose what level of alert will trigger sending the log entry or trap message as defined by the
Severity Name. Select critical to send only critical events to the Switch’s log or SNMP agent.
Choose warning to send critical and warning events to the Switch’s log or SNMP agent.
Select information send informational, warning and critical events to the Switch’s log or
SNMP agent.
Click Apply to implement the new System Severity Settings.
SNTP Settings
Time Settings
This window is used to configure the time settings for the Switch.
To view this window, click Administration > SNTP Settings > Time Settings, as shown below:
Figure 2 - 30 Time Settings window
The following parameters can be set or are displayed:
To Next Page
Loading...
Need help?
General