xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
36
Parameter Description
Current Time: Status
System Boot Time
Displays the time when the Switch was initially started for this session.
Current Time
Displays the Current Time.
Time Source
Displays the time source for the system.
Current Time: SNTP Settings
SNTP State
Use this pull-down menu to Enabled or Disabled SNTP.
SNTP Primary Server
The IP address of the primary server from which the SNTP information will be taken.
SNTP Secondary Server
The IP address of the secondary server from which the SNTP information will be taken.
SNTP Poll Interval in
Seconds (30-99999)
The interval, in seconds, between requests for updated SNTP information.
Current Time: Set Current Time
Year
Enter the current year, to update the system clock.
Month
Enter the current month, to update the system clock.
Day
Enter the current day, to update the system clock.
Time in HH MM SS
Enter the current time in hours, minutes, and seconds.
Click Apply to implement your changes.
Time Zone and DST
The following window is used to configure time
zone and daylight savings time settings for SNTP.
To view this window, click Administration >
SNTP Settings > Time Zone and DST, as shown
on the right:
Figure 2 - 31 Time Zone and DST Settings window
The following parameters can be set:
To Next Page
Loading...
Need help?
General