D-Link xStack DGS-3426 - Page 25

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3400:4#config ports 1-3 speed 10_full learning enable state enable
Command: config ports 1-3 speed 10_full learning enable state enable
Success.
DGS-3400:4#
show ports
Purpose
Used to display the current configuration of a range of ports.
Syntax show ports {<portlist>} {description | err_disabled}
Description
This command is used to display the current configuration of a
range of ports.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
description – Adding this parameter to the show ports command
indicates that a previously entered port description will be included
in the display.
err_disabled – Use this to list disabled ports including connection
status and reason for being disabled.
Restrictions
None.
Example usage:
To display the configuration of all ports on the switch:
DGS-3400:4#show ports
Command show ports:
Port Port Settings Connection Address
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
------ -------- --------------------- --------------------- --------
1 Enabled Auto/Enabled Link Down Enabled
2 Enabled Auto/Enabled Link Down Enabled
3 Enabled Auto/Enabled Link Down Enabled
4 Enabled Auto/Enabled Link Down Enabled
5 Enabled Auto/Enabled Link Down Enabled
6 Enabled Auto/Enabled Link Down Enabled
7 Enabled Auto/Enabled Link Down Enabled
8 Enabled Auto/Enabled Link Down Enabled
9 Enabled Auto/Enabled Link Down Enabled
10 Enabled Auto/Enabled 100M/Full/None Enabled
11 Enabled Auto/Enabled Link Down Enabled
12 Enabled Auto/Enabled Link Down Enabled
13 Enabled Auto/Disabled Link Down Enabled
14 Enabled Auto/Disabled Link Down Enabled
15 Enabled Auto/Disabled Link Down Enabled
16 Enabled Auto/Disabled Link Down Enabled
17 Enabled Auto/Disabled Link Down Enabled
18 Enabled Auto/Disabled Link Down Enabled
19 Enabled Auto/Disabled Link Down Enabled
20 Enabled Auto/Disabled Link Down Enabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
22