FOLDING INSTRUCTIONS
Please follow the steps as outlined below when folding the screen material
for packing:
1. Make sure the surface does not come in contact with a painted,
varnished, plastic, or dyed surface or object. Prolonged contact with
any one of these materials could cause a chemical reaction and
compromise the screen’s physical or optical quality. This can be
accomplished by laying a white clean cotton fabric or paper (slightly
larger than the screen size) on a flat surface prior to folding the
screen.
2. With the dull side up on Da-Tex, Dual Vision, and Da-Mat and the
pearlescent side up on Pearlescent and Cinema Vision fold the
fabric in half from top to bottom. (A 7.5' x 10' screen is now
3.75' x 10'.) Make sure that the screen never comes in contact with the
black binding, grommets or snap buttons. Please note that for this to
happen, one must make sure all folds subsequent to the first fold stop short
of black binding material as illustrated below.
STEP ONE
STEP FIVE
STEP FOUR
STEP THREE
STEP TWO
DO NOT FOLD
FABRIC ONTO
BLACK BINDING,
GROMMETS OR
SNAP BUTTONS
DO NOT FOLD
FABRIC ONTO
BLACK BINDING,
GROMMETS OR
SNAP BUTTONS
3. Place clean tissue paper or white 100% cotton material between
the folds.
4. If the folded area is more than 3 feet wide (which is the case in the
above example), then continue to fold until the folded area is equal
to or smaller than 3 feet wide. Please remember that all folds
subsequent to the first fold must stop short of the black binding material to
keep the viewing area away from it and the snap buttons as illustrated
above.
STORAGE AND CLEANING
STORAGE
1. The screen surface must be stored in its pouch when not in use to
prevent damage and discoloration.
2. While in storage, avoid extreme temperature conditions. If surface
becomes sticky, see cleaning instructions below.
3. If stored at temperatures far below room temperature, allow the
screen to warm up to room temperature before unfolding. This will
ensure the film is being handled in its most flexible state and will
prevent surface cracks.
CLEANING
Da-Tex, Dual Vision, and Da-Mat surfaces can be cleaned as follows:
Using a white clean cloth (100% cotton preferred) that is dampened
with clear water, gently wipe the area in one direction. Do not use a
circular motion. Using a dry 100% cotton cloth, wipe dry after each
cleaning session. To clean a stubborn stain or a sticky surface, use
denatured alcohol (methanol or methyl alcohol) following the same
procedure as for water. For extremely stubborn stains, use V M & P,
Naphtha or Super Naphtha and follow the same procedure as for water.
5. Once the top to bottom folding is completed, fold from left to right
and continue folding until the folded area is small enough to fit into
the vinyl pouch. Please note that the final fold must stop short of the
black binding material to keep the viewing area away from it and the snap
buttons as illustrated.
To Next Page
Loading...
