20
Special Functions of the Flex Dosimeter
Special Notes
• It is not possible to enter a backup time of 60 seconds. You must enter 1 minute instead.
• A short beep is sounded for every valid key entered. A long beep is sounded when an invalid
key is entered.
• If power goes off during a treatment, the system will remember how much of the treatment has
elapsed. When power is restored, your device will be on hold. To continue, press START.
• The small orange light above the display will be lighted when a treatment is in process. It will
blink when the treatment is paused.
Flex Timer Instructions
Determining a treatment time
(See additional instructions for the 1 Series)
When using time as a dose, there are two treatment methods that
can be used. The simplest is to start at a prescribed time and then
increase treatment times by a specific time increment or by a
percentage, per your physician’s protocol. Another method is to use
the factory power output levels (shown on the Power Output
Certificate) to determine estimated “time equivalents” needed to
deliver doses in milliJoules (UVB) or Joules (UVA or visible light).
To determine a “time equivalent”, consult the laminated Time Chart
that is provided and find the power output on the top row (horizontal
axis). The numbers in the column on the left (vertical axis)
Function Press then Press then Press
To wake up device Any Key
To pause a treatment Enter, End or Power
To continue a treatment Enter
To check how much time
is left on your treatment
Mode Press Mode again to revert back to monitoring
the dose count up
To check the power output Power (Can only be checked while lamps are on)
To end a treatment End Twice
If you make a mistake
entering a dose
Repeatedly press Left Arrow Key until all zeros are displayed
To check the age (in
hours) of your lamps
Mode plus ◄ (Lamps must be off)
End,
then
Mode
plus ▲ then
To treat another section of
the body using the same
treatment time
Press and release both keys at the same
Enter
To Next Page
Loading...
Need help?
General
