DAB DIVERTRON 1000 - Starting the Pump; Recommendations for Operation; Maintenance and Cleaning

2
•
The best working condition is with the pump completely submersed in water.
The motor’s cooling system allows the use at the minimum suction height for short periods.
•
The pump is equiped with a stainless steel anti-deposit suction grid.
The temperature of the fluid being pumped must never exceed 95°F
The pump must not be used to pump salt water, sewage, flammable, corrosive or explosive
liquids (e.g. petroleum oil, petrol, and thinners), grease, oils or foodstuffs.
Comply with the rules and regulations of the local water authority when using the pump for the
supply of domestic water.
3.
STARTING THE PUMP
Given the different provisions applicable to the safety of electric systems in different countries,
make sure that the pump system, as concerns its intended use, is in accordance with current
legislation.
Before starting the pump, make sure that:
•
The voltage and frequency specified on the pump’s nameplate coincide with those of the
available power supply;
•
there are no signs of damage to the pump or its power cord;
•
The electric connection is made in a dry place, protected against any risk of flooding;
•
The electric system is complete with a residual current circuit-breaker GFI Ground fault Indicator
(l An S 30 mA) and an efficient earthing connection;
•
Any extension cords must comply with requirements of the DIN VDE Standard 0620.
4.
RECOMMENDATIONS
To ensure the proper operation of the pump, it is important to comply with the following
recommendations:
The pump must only be used when immersed in water.
The pump must be placed in a stable position inside the trap or the lowest place where it is
installed.
• ThePeriodically, it is advisable to make sure that no dirt ( leaves, sand, etc.) has accumulated in
the trap or arounf the suction grid.
MAINTENANCE AND CLEANING
lt is absolutely essential to prevent any risk of the pump freezing. In the event ol freezing temperatures.
remove the pump from the liquid, empty it and keep it in a place where it cannot freeze.
The pump must be disconnected from the mains before performing any cleaning operation.
The pump is maintenance free.