Need help?Do you have a question about the DACE HT18/36 and is the answer not in the manual?
Critical safety warning regarding direct connection of mains voltage to the controller.
Details on gate mass, pull force, running force, and size limits for operators.
Information on transformer voltage, supply voltage, current draw, and standby power.
Setting up safety parameters for gate collision detection.
Procedure for programming remote control buttons to trigger the gate.
Configuration options for safety beams, including auto close and reverse functions.
Procedure for adding new remotes without using group assignments.
Process for adding remotes to specific groups for organized access control.
Sets the distance the gate travels for pedestrian access.
Sets collision sensing sensitivity for pedestrian closing.
Allows gate to auto close in pedestrian mode.
Delay for gate closing in pedestrian mode.
Gate closes automatically after pedestrian passes safety beams.
Gate reverses to pedestrian open if closing beam is blocked.
Activates alarm if safety beams are blocked for extended period.
Activates alarm immediately if safety beams are blocked.
Activates alarm if the operator lid is lifted.
Activates alarm if the gate remains open for too long.
Activates alarm if the gate is forced open while closed.
Sets duration beams can be blocked before ambush alarm.
Enables the use of an electric lock with the operator.
Enables the use of a magnetic lock with the operator.
Reduces power consumption by switching magnetic lock off when gate is open.
Allows gate to move from locked position before restoring lock state.
Keeps lock unlocked for a short period after gate starts closing.
Automated programming of open and closed gate limits.
Configuration of closing force, opening force, and anti-crush gap.
Defines gate movement phases: ramp, crawl, and stop.
Sets the maximum closing speed of the gate.
Sets delay before gate opens after a trigger.
Sets delay before gate closes after a trigger.
Ignores all triggers when enabled, activated via input or remote.
Detects vehicles to control access or prevent closing on a vehicle.
Procedure for upgrading software using USB flash drive or Android phone.
Alternative procedure for software update or restoration via USB.
Indicates low battery voltage and potential causes or solutions.
Detects gate exceeding parameters or hitting an obstruction.
Details on processor, supply, motor drive, inputs, outputs, display, and navigation.
Information on transformer input, controller input, motor, and battery charger.
Specs for multistage electronic collision detection, sensing, and safety devices.
Lists alarm inputs, outputs, lock, light, gate mass, speed, and operations per day.
General| Model | HT18/36 |
|---|---|
| Category | Gate Opener |
| Operating Temperature | -20°C to +55°C |
| Power Supply | 230V AC |
| Motor Type | DC Motor |
To Next Page