To Next PageTo Next Page
Need help?Do you have a question about the dacell DN-10W and is the answer not in the manual?
General| Brand | dacell |
|---|---|
| Model | DN-10W |
| Category | Measuring Instruments |
| Language | English |
Explains methods for calibrating the device using actual load or rated sensor output.
Details the functionality of Hold and Peak Hold modes for capturing measurement values.
Describes how to set limits and use comparison output signals for monitoring.
Explains the feature for saving setup values to flash memory, preventing data loss.
Details the automatic reset function for system stability against external factors like noise.
Lists available optional interfaces and modules like BCD, RS232C, and RS485.
Specifies the power supply requirements for the device, including AC and optional DC.
Provides crucial guidelines for safe and proper installation to prevent damage or malfunction.
Offers essential precautions for operating the device correctly to ensure accurate measurements.
Explains how to utilize Peak Hold and Sample Hold functions to capture specific measurement values.
Describes the four comparison modes (Decision, High, Low, Low&High) and their relay outputs.
Outlines the three main setting modes: Function, Digital Calibration, and Actual Load Calibration.
Details the procedure for setting various functions (F-00 to F-52) using the front panel keys.
Explains how to configure settings for the comparison output relays in Decision and Limit modes.
Provides a comprehensive list of available function codes (F-00 to F-52) with their descriptions and default values.
Guides users on calibrating the device using the sensor's rated output and capacity values.
Explains how to calibrate the indicator using a known physical load applied to the sensor.
Describes the procedure for saving and restoring device configuration settings to prevent data loss.
Details how to lock the front panel keys to prevent accidental operation after setup.
Explains the programmable BCD interface for outputting weight values in BCD format to PLCs or computers.
Provides wiring instructions for RS232C and RS485 serial communication interfaces.
Lists the communication parameters and types for EIA-232C and EIA-485 serial ports.
Details the standard ASCII-based communication protocols for data transmission and command control.
Explains the Modbus RTU protocol implementation, including function codes and register mapping.
