To Next PageTo Next Page
Need help?Do you have a question about the dacell DN-50W and is the answer not in the manual?
General| Brand | dacell |
|---|---|
| Model | DN-50W |
| Category | Measuring Instruments |
| Language | English |
Highlights calibration, hold modes, comparison output, data back-up, watch dog, and options.
Installation and usage guidelines to ensure safe operation and prevent errors.
Explains Peak Hold and Sample Hold modes for capturing measured values.
Details four comparison modes for relay output based on set limits.
Overview of Function, Digital Calibration, and Actual Load Calibration modes.
Key operation sequence for setting function parameters F-00 to F-52 for most models.
Key operation sequence for setting function parameters specific to the DN-30W model.
Procedures for configuring relay outputs in Decision and Limit modes.
A list of function codes (F-00 to F-52) and their descriptions/settings.
Procedure for digital calibration using rated output and capacity values.
Digital calibration procedure specific to the DN-20W model, including output type selection.
Digital calibration procedure for the DN-25W model, including setting rated output and capacity.
Calibrating using actual load to adjust display values and improve linearity.
Explains how compensation increases linearity and notes on forward/reverse output calibration.
Guides on calibration when sensor output is unknown, including obtaining rated output.
Special notes for calibrating DN-20W, focusing on modifying rated capacity.
Steps to save the device's current configuration.
Steps to load a previously saved configuration.
Details the BCD interface for data output to external systems.
Instructions for wiring RS232C and RS485 serial communication interfaces.
Specifies port types, method, baud-rate, parity, data bit, and stop bit.
Explains Stream and Command modes for standard communication.
Provides register map and function codes for Modbus RTU communication.
