English18
Care and maintenance
Care and maintenance
Removing the filters
The filters are under the hood toward the rear. These external components lie directly
above all heat, steam, and particulates that are drawn upward into the blower(s).
A B
C D
Model Shown: DHD48
REAR
BOTTOM
A. Main power switch
B. Tension clip
C. Filter knob
D. Filter
1. Tension clips at the front of the hood
hold the filters in place.
2. You can easily access the main power
switch when the filter beneath it is
removed.
3. In performing this procedure, take
care not to bump the switch or scratch
the grease channel along the hood’s
bottom-rear edge.
4. If you cannot reach the filters from
the floor, Dacor recommends you use
a stepstool or similar sturdy device to
help you reach up into the hood.
To Next Page
Loading...
