13
SENSOR MODES
Dacor's Sensor is a semi-conductor device that detects
the vapor (moisture and humidity) emitted from the food
as it heats. The sensor adjusts the cooking times and
power level for various foods and quantities.
Using Sensor Settings:
1. After oven is plugged in, wait 2 minutes before
using SENSOR MODES.
2. Be sure the exterior of the cooking container and
the interior of the oven are dry. Wipe off any mois-
ture with a dry cloth or paper towel.
3. The oven works with foods at normal storage tem-
perature. For example, popcorn would be at room
temperature.
4. Any SENSOR MODES selection can be pro-
grammed with More or Less Time Adjustment. See
page 25.
5. More or less food than the quantity listed in the
chart should be cooked following the guidelines in
any microwave cookbook.
6. During the first part of SENSOR MODES, the food
name will appear on the display. Do not open the
oven door or touch STOP/CLEAR during this part
of the cooking cycle. The measurement of vapor
will be interrupted. If this occurs, an error message
will appear. To continue cooking, touch the STOP/
CLEAR pad and cook manually.
When the sensor detects the vapor emitted from
the food, remainder of cooking time will appear.
The door may be opened when remaining cooking
time appears on the display. At this time, you may
stir or season food, as desired.
7. If the sensor does not detect vapor properly when
popping popcorn, the oven will turn off, and the
correct time of day will be displayed. If the sensor
does not detect vapor properly when cooking other
foods, ERROR will be displayed, and the oven will
turn off.
8. Check food for temperature after cooking. If addi-
tional time is needed, continue to cook manually.
9. Each food has a cooking hint. Touch HELP GUIDE
pad when the HELP indicator is lighted in the
display.
Covering Foods:
Some foods work best when covered. Use the cover
recommended in the SENSOR MODES chart for
these foods.
1. Casserole lid.
2. Plastic wrap: Use plastic wrap recommended for
microwave cooking. Cover dish loosely; allow
approximately 1/2 inch to remain uncovered to
allow steam to escape. Plastic wrap should not
touch food.
3. Wax paper: Cover dish completely; fold excess
wrap under dish to secure. If dish is wider than
paper, overlap two pieces at least one inch to cover.
Be careful when removing any covering to allow
steam to escape away from you.
EXAMPLE:
You can cook many foods by simply selecting the food
and touching START/INSTANT ON. You don’t need to
calculate cooking time or power level.
• Suppose you want to reheat canned chili.
REHEAT
PROCEDURE
1
Touch START/
INSTANT ON pad.
2
Touch REHEAT pad.
When the sensor detects the vapor emitted from the
food, the remainder of cooking time will appear.
NOTE:
The FRESH VEGETABLES and POULTRY settings
have 2 choices. Follow directions in the Interactive
Display to choose desired option.
START
INSTANT ON
To Next Page
Loading...
Need help?
General
