Oven settings are not correct. Follow mode selection and clock settings as
specified in the SELF-CLEANING section.
Oven is set for Delay Timed Cleaning. Oven will turn on automatically at preset time. If
desired, press "CANCEL.SECURE" touch pad
to cancel out Delay Timed Cleaning.
7. Oven light will not work.
8. Door will not open.
Light bulb is burned out
Oven is in Self-Clean mode.
Follow REPLACING THE OVEN LIGHT section
If oven is hot, door latch wilI release
automatically when oven temperature falls betov
390°F at end of cycle.
9. Oven will not heat after Self Cleaning.
Time of day is not set due to power failure.
If Self-Clean was just selected and the oven
is still cool, press "CANCEL.SECURE" to turn
off Self-Clean. The door will open in about 30
seconds.
Press "CLOCK" touch pad, then press
"TIME.TEMP" pad to set correct time of day.
Oven settings are not correct. Follow mode selection and clock settings as
specified in the OVEN OPERATION section.
Troubleshooting Guide (Continued)
Oven will turn on automatically at preset time. If
desired, press "CANCEL.SECURE" touch pad
to cancel out of Delay Timed mode.
Clock Display Cause
F0. Touch pad is stuck in depressed position.
F1. Relay circuit failure.
F2. Oven temperature exceeded the clean runaway temperature (Self-Clean mode
only) or the cooking runaway temperature (cooking modes only).
F3. Short circuit in the oven temperature sensor.
F4. Open circuit in the oven temperature sensor.
F6. Failure in the EEPROM check comparison. (Only time of day and timer will
operate.)
F7 Failure of the Self-Clean automatic door latch circuit.
F8. Failure of the door latch motor. Occurs when the motor runs for two minutes
without the door locking in Self-Clean mode.
Oven Failure Codes
11
To Next Page
Loading...
