English24
Installation instructions
Installation instructions
Level refrigerator
Before installing refrigerator, assembly the leveling legs carried with installation parts.
01 02
03
05
04
CAUTION
After assemble the leveling legs possible
to be damaged the oor due to small gap
between leveling legs and oor.
First, push the jack between a caster and
evaporation tray with caring for water
hose.
Second, lift the refrigerator up turning
clockwise the jack.
And then, insert the leveling legs fully.
NOTE
The refrigerator must be level. If it is not,
the doors may not align evenly at the top.
CAUTION
The rear leveling legs and front leveling legs are limited to a maximum height adjustment
of 3/4” (20 mm). If the installation requires more than 2118 mm height, the installer
should elevate the refrigerator on a sheet of plywood or runners. Cabinet trim could be
added across the top of the opening to shorten the opening.
If you attempt to raise the refrigerator more than 20 mm you will damage the front and
rear leveling legs.
TBI_Dacor_Installation_DA68-03583A-03_EN.indd 24 2020-10-15 10:39:36
To Next Page
Loading...
Need help?
General
