English26
Installation instructions
Installation instructions
Turn on the power
Raise Grille Panel
Water Filter
Master Power Switch
• Set the Master Power Switch to the “I”
(ON) position.
• Check to make sure power to
refrigerator is on by opening
refrigerator door to see if interior lights
are on.
• The temperature controls are preset
at 3 °C for the Fresh Food section and
-18 °C for the Freezer section.
• Allow 24 hours to stabilize before
making adjustments.
Start icemaker
Test Button
• Press the icemaker Test Button at the
upper part of the freezer compartment
for 2 seconds.
- After the ice tray rotates, it goes
back to its initial position. When it
completes its rotation and water
is supplied to the supply line, the
operation of the icemaker is normal.
• Discard the rst full bucket of ice cubes.
Install kickplate
Supplied Kickplate
• Locate the supplied kickplate (shipped
taped to the top of the refrigerator).
Install with 2 screws provided.
• The vented kickplate must remain
unobstructed for proper air ow.
TBI_Dacor_Installation_DA68-03583A-03_EN.indd 26 2020-10-15 10:39:37
To Next Page
Loading...
Need help?
General
