0
-6
DS42-W00 Nov. 2007
DK752C/DK902C
SAFETY FIRSTGENERALENGINECLUTCHTRANSMISSION REAR AXLEBRAKEFRONT AXLESTEERINGHYDRAULICELECTRICCABINA/C SYSTEM
2.7 USE OF APPROPRIATE TOOLS AND
EQUIPMENT
Use the appropriate tools and proper size. If an in-
appropriate tool is used, it can slip which can dam-
age parts or injure you.
Do not confuse units (mm, inch, etc.).
Use the air impact wrench only when unscrewing
the bolts or nuts. Such wrench should not be used
when assembly precisely machined parts which its
tightening torque should be strictly observed. It can
cause malfunctions.
Be careful of a socket popped out due to the turning
force when using the air impact wrench. Especially,
be extra cautious when working on connection or
socket with joint.
•
•
•
•
When lifting the tractor with a hydraulic jack or a
hoist, fi x it fi rmly and install the auxiliary support.
Never work under the tractor if the support and the
hydraulic jack (hoist) are not installed.
When using a hydraulic jack or a hoist, do not use
it over the limit of the equipment and the conveying
belt.
Make sure that the hydraulic lock operates properly
before using the hydraulic jack. Improper use of
lock can cause a serious accident.
Check the buttons and operating direction of the
hoist before using it. Improper operation can cause
a serious accident.
Do not use wooden blocks or bricks as support un-
der the tractor. As the tractor’s weight is continuous-
ly applied to them, they can be broken or collapsed.
•
•
•
•
•
2.8 HANDLING OF HAZARDOUS MATERIALS
Do not blow out hazardous materials, such as clutch
dust, with compressed air. Inhaling such hazardous
materials can damage your health.
•
T46W022A
No genuine DAEDONG part contains asbestos.
REMARK
These materials should be rinsed or wiped away
after spraying with oil.
•
SAFETY FIRST - SAFETY TIPS
M39_AU.indb 섹션1:6M39_AU.indb 섹션1:6 2007-10-29 오후 8:22:402007-10-29 오후 8:22:40
To Next Page
Loading...
