6-16 DK65/75/80/90
LIFT CYLINDER INSPECTION
(IF EQUIPPED)
1. If the lift does not operate when ad-
justing the lift switch (Up and Down),
perform inspection in the following
order:
(1) Stop the engine
(2) Press the push button (Left and
Right) on both sides of the control
valve assembly (located on the top of
the lift hydraulic cylinder).
(3) Restart the engine and activate the
lift using the lift switch.
2. When the switch is not operated for a
long time after the horizontal adjust-
ment of the solenoid valve, the lift may
leak down. Inspect lift operation
regularly.
CAUTION
If the lift does not operate after
performing this procedure, con-
sult your DAEDONG dealer.
628O626A
(1) Push button
CHECKING HOSES
Rubber hoses such as fuel lines and ra-
diator hoses will deteriorate even when
the tractor is not being used. Hoses and
clamps should be replaced immediately if
damaged, and every 2 years regardless
of operating hours. Always check to see
that hoses and clamps are tight before
operating the tractor.
CAUTION
When replacing fuel hoses, take
extra care to avoid fuel system
contamination which will cause
engine malfunction and injection
pump damage.
WARNING
Replace damaged fuel line and
repair any other fuel leaks imme-
diately to avoid fire and serious
personal injury.
LUBRICATION POINTS
Lubricate all points that have grease fit-
tings with a DAEDONG approved lubri-
cating grease according to the mainte-
nance chart.
Always add grease before and after
working in water.
628O624A
(1) Grease Fitting (zerk)
(2) Front & Rear Bracket
(3) Lift Cylinder Bracket
(4) Lifting Linkage
To Next Page
Loading...
