Always follow the proper starting
procedure described below.
This motorcycle is equipped with a side
stand ignition cut-off system. The
engine cannot be started if the side
stand is down, unless the transmission
is in neutral. If the side stand is up, the
engine can be started in neutral or in
gear with the clutch lever pulled in.
After starting with the side stand down,
the engine will shut off if the
transmission is put in gear before
raising the side stand.
<PREPARATION>
Before starting, insert the key, turn the
ignition switch ON and confirm the
following:
The transmission is in NEUTRAL
(neutral indicator light ON)
<
WHEN ENGINE IS COLD
>
1. Close throttle grip, and press starter
button.
2. Once engine is started, pull and release
throttle grip repeatedly to run engine
idle until engine is heated.
<
WHEN ENGINE IS HOT
>
1. Close throttle grip and press starter
button. (If engine is not started with 1-2
times trial.
2. If engine is not started with throttle grip
closed, open throttle grip approximately
1/8 to 1/4 and press starter button.
STARTING THE ENGINE
Do not keep the starter button
pressed for more than 5 seconds at a
time. Release the starter button for
approximately 10 seconds before
pressing it again.
Check to see if the MIL is illuminat for
3 second.
27
●
●
●
●
●