Daewoo Cyclone Freedom - Fitting the Wall Bracket for Storage

13
Cyclone Freedom 22.2V Cordless Vacuum
Cleaner
FLR00010
User Manual
IMPORTANT – RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
• Allow the filters to thoroughly dry out for 24 hours before reassembly and
reuse.
* WARNING! DO NOT continue to use your vacuum cleaner once the Dust
Compartment (4) is full as permanent damage may occur to the appliance.
Recommended filter cleaning intervals
Filter Type
Recommended cleaning period
WARNING! Ensure the filters are cleaned periodically according to the table
above, failure to clean the filters regularly will severely impair the performance
and permanent damage may occur to the appliance.
Fitting the Wall Bracket for Storage of your Vacuum Cleaner
Fit the Wall Bracket (21) to the wall using supplied Wall Plugs and Screws (or
alternative appropriate fixings for the wall) as follows:
WARNING! Be careful whilst drilling the holes, care must be taken not to
damage concealed cables and pipes in the wall. If in doubt obtain the services of a
qualified tradesman to fit the wall bracket.
1. Choose a suitable position to mount your
vacuum cleaner on the wall.
2. Measure 1 metre above the floor and mark the
wall with a pencil as shown right.
1 & 2
• Shake out debris when you empty the dust
container
• Rinse under war m water once a month
• Allow to dry thoroughly for 24 hours before reuse.
• Shake out debris once a month
• Rinse under war m water once a month.
• Allow to dry thoroughly for 24 hours before reuse.
Conical Hepa Filter
Cyclonic Filter
Air Outlet Filter
• Shake out debris once a month
• Remove the sponge filter from around the Hepa
filter and rinse under war m water once every 3-6
months
• Allow to dry thoroughly for 24 hours before reuse.