3. Hold the Wall Bracket level on the wall in
line with the 1 metre mark made and mark
the position of the two screw holes through
the Wall Bracket using a pencil as shown.
4. Remove the Wall Bracket and using the
marks, drill holes in the wall using a suitable
6mm masonry drill bit (not supplied).
5. After drilling the holes, push the two supplied
Wall Plugs into the holes as shown right:
6. Screw the Wall Bracket to the wall using the
supplied screws:
7. Hang your Vacuum cleaner on the Wall
Bracket as shown below:
To Next Page
Loading...
