- 108 -
Maintenance Section
5. Remove and discard oil filter element.
6. Wipe sealing surface of oil filter element
mounting base. Make sure all of the old gasket is
removed.
7. Before installing a new filter element, apply a
small amount of clean engine oil to the filter ele-
ment gasket.
8. Install the new filter element. When the gasket
contacts the base, tighten it 3/4 of a turn more. Do
not overtighten.
9. Raise the lift truck, remove the blocking and
lower the lift truck.
10. Fill the crankcase. See Ò Refill Capacities Ó.
11. Start the engine and allow the oil to fill the filter
and passages.
12. Check for oil leaks.
13. Stop the engine and measure the oil level.
Maintain the oil level to the FULL mark on the dip
stick.
14. Close hood and seat assembly.
PCV Valve System - Inspect,
Clean
Gasoline and LP-Gas Engines
1. Loosen the hose clamps and remove the PCV
valve.
2. Shake the PCV valve. If it rattles, reinstall it. If it
does not rattle, replace it.
3. Tighten the hose clamps.
IA3M4095
IA3M4094
IA3M4095
To Next Page
Loading...
Need help?
General
