Operation Section
-56-
Seat Switch System (If Equipped)
The lift truck is equipped with a SEAT SWITCH
SYSTEM. In normal operation if the direction lever is
placed in either forward or reverse, the lift truck will
move at a speed proportional to the accelerator
pedal's position. If the operator leavers the seat
without setting the parking brake, within three
seconds after leaving the seat, the SEAT SWITCH
SYSTEM will automatically disengage the
transmission. The directional lever, however, will
remain in that forward or reverse location although
internally the transmission will have shifted into
neutral.
Before exiting the lift truck, the parking brake should
always be applied.
.
WARNING
WHEN LEAVING MACHINE APPLY PARKING
BRAKE!
PARKING BRAKE IS NOT AUTOMATICALLY
APPLIED.
NOTE: Some trucks may be equipped (ask your dealer
if this applies to your truck) with an alarm that
will sound if the parking brake is not applied
when leaving the machine.
NOTICE
1. Prior to operating the lift truck, be sure to
understand and check the SEAT SWITCH
SYSTEM.
2. While in normal operation and on level ground,
select a direction with the derectional lever and
with the park brake released. You will note that
the truck will move slowly in the selected
direction. If you lift yours hips off of the seat,
within three seconds, the SEAT SWITCH
SYSTEM will desengage the transmission
allowing the truck to coast but not automatically
stop.
3. To restore the lift truck to normal operation,
while sitting in the operator's seat depress the
brake pedal to hold the lift truck, return the
directional lever to the neutral position, and
then reselect a direction of travel (either forward
or reverse). The transmission will then re-
engage.
4. If seat or seat switch replacement becomes
necessary, be sure to use genuine DOOSAN
Infracore lift truck parts. Lift trucks should never
be operated without an operational SEAT
SWITCH SYSTEM.
To Next Page
Loading...
Need help?
General
