EasyManuals Logo

Daewoo D45SC-2 User Manual

Daewoo D45SC-2
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
Operation Section
-87-
7. To change the lift truck direction of travel, release
the accelerator pedal.
8. Push down on the service brake pedal to reduce the
lift truck speed as necessary.
9. Move the directional lever to the desired direction of
travel. Slowly push down on the accelerator pedal
as the lift truck changes direction.
10. When the direction change is completed, continue
to push down on the accelerator pedal to obtain the
desired travel speed.
11. To stop the lift truck when traveling in either
direction, release the accelerator pedal.
12. Push down on the service brake pedal and bring the
lift truck to a smooth stop.
Inching
NOTE: The purpose of the inching pedal is to provide
precise lift truck inching control at very slow
travel speed and high engine rpm. This is used
for fast hydraulic lift, during load approach, pick
up or load positioning.
1. To inch (creep) in either direction, slowly push down
on the inching pedal. This will start to apply the
service brakes and allow the transmission clutch
discs to slip.
2. Vary the position of the inching pedal and the
accelerator pedal to control the inching speed and
distance.
3. Pushing down further on the inching pedal will
disengage the transmission completely and apply
the service brakes fully to stop and hold the lift truck.
This will provide full engine power for fast hydraulic
lift.

Table of Contents

Other manuals for Daewoo D45SC-2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Daewoo D45SC-2 and is the answer not in the manual?

Daewoo D45SC-2 Specifications

General IconGeneral
BrandDaewoo
ModelD45SC-2
CategoryForklifts
LanguageEnglish

Related product manuals