www.daewoopower.bg
15
5. START AND STOP
Control before starting
For reasons of safety follow these recommendations!
• Check the blade to ensure that no cracks have formed at the bottom of the teeth or by the centre hole.
• The most common reason why cracks are formed is that sharp corners have been formed at the bottom of the
teeth while sharpening or that the blade has been used with dull teeth. Discard a blade if cracks are found.
• Check that the support flange is not cracked due to fatigue or due to being tightened too much. Discard the
support flange if it is cracked.
• Ensure the locking nut has not lost its captive force. The nut lock should have a locking force of at least 1.5 Nm.
The tightening torque of the locking nut should be 35-50 Nm.
• Check that the guard is not damaged or cracked. Replace the guard if it is exposed to impact or is cracked.
• Check that the trimmer head and shield are not damaged or cracked. Replace the trimmer head or shield if they
are exposed to impact or are cracked.
• Never use the machine without a guard or spray guard nor with a defective guard.
Start and stop
WARNING!
The complete clutch cover with shaft must be fitted before the machine is started, otherwise the clutch can become
loose and cause personal injury. Always move the machine from the filling area before starting. Place the machine
on a flat surface. Ensure the cutting equipment cannot come into contact with any object. Make sure no unauthori-
sed persons are in the working area, otherwise there is a risk of serious personal injury. The safety distance is 15
metres.
Cold engine
IGNITION: Set the stop switch to the run position. CHOKE: Set the choke control in the choke posi-tion.
AIR PURGE: Prime with fuel by pressing the dia-phragm repeatedly until fuel begins to run back into the tank through
the transparent fuel hose.
Warm engine
Use the same starting procedure as for the cold engine, but do not set the choke control in the choke position. Set
the throttle to the start position by pressing the throttle trigger and then pressing the red button next to the stop
button.
Stop
Stop the engine by switching the stop switch to the stop setting.
To Next Page
Loading...
Need help?
General
