What causes too much smoke from the chimney of my Daewoo Pressure Washer?
Excessive smoke from the chimney of your Daewoo Pressure Washer can be due to incorrect combustion, so clean the fuel filter. It could also be caused by impurities or water in the fuel, requiring you to clean the boiler. If neither of these resolves the issue, empty and carefully clean the tank.
What to do if there is water in the oil of my Daewoo DHPW7300 Pressure Washer?
If you find water in the oil of your Daewoo Pressure Washer, it could be due to a worn-out O-ring casing, so check and/or replace the O-ring. High moisture in the air can also cause this issue; in that case, replace the oil with double the suggested frequency. Finally, completely worn-out seals can also lead to water contamination; replace the seals.
What causes insufficient detergent suction in my Daewoo DHPW7300 Pressure Washer?
If your Daewoo Pressure Washer isn't drawing detergent properly, first ensure there is detergent in the tank. If the tank is full, the injector may be encrusted, requiring cleaning. Alternatively, the coil, tube, or lance may be clogged, needing cleaning or descaling.
How to fix filtrations of water from the drains between casing and head in my Daewoo Pressure Washer?
If water is leaking from the drains between the casing and head of your Daewoo Pressure Washer, it could be due to worn-out seals, so replace them. The piston may also be worn out, requiring replacement. Additionally, the O-ring of the piston cap might be worn, so replace that seal as well.
What to do if my Daewoo Pressure Washer boiler does not start when turning on the burner switch?
If your Daewoo Pressure Washer boiler doesn't start when you turn on the burner switch, first check the fuel level in the tank and ensure the rigid suction pipe is clean. If that's not the issue, the fuel filter might be clogged, so replace it. A blocked or burnt-out fuel pump could also be the cause, requiring replacement. Also, a damaged thermostat can prevent the boiler from starting and should be replaced. For insufficient or totally lacking ignition spark, contact an authorised service centre. The space among the electrodes may not be correct, so check the positioning. Finally, a burnt-out fuse can cause this issue, so replace it.
What causes filtrations of oil from the drains between head and casing in Daewoo Pressure Washer?
If oil is leaking from the drains between the head and casing of your Daewoo Pressure Washer, it is likely due to worn-out O-ring seals of the casing, so replace the seals.
General| Brand | Daewoo |
|---|---|
| Model | DHPW7300 |
| Category | Pressure Washer |
| Language | English |
To Next Page
