64
d). AppsTest
This setting depends on PCB state.
When you want to program PCB without sofware, then this
option should be OFF (not mark).
In case of upgrade software to newer version you need to
switch AppsTest option ON.
If this option is not corect you will have problem with pro-
gramming IC.
Optional you can set AppsTest to OFF and forced
AppsTest manually on the PCB using jumper and switch
(more explanations at point 5).
e). Batch file (*.txt)
If you want to use Batch file to programming IC, you
need to switch ON (mark) Batch file option and choose
file using Browse button.
f). Manual mode
In Manual mode you need to set Flash image
(*.bin,*.hex) and Flash driver (*.bin,*.hex)
Software Install & Upgrade
To Next Page
Loading...
