16
WARNING
The product is equipped with a centrifuga! clutch mechanlsm, so the
cuttlng attachment begins to rotate as soon as the engine is started by
putting the throttle into the start position. When starting the engine,
place the product onto the ground in a flat clear area and hold it firmly in
place so as to ensure that neither the cutting part nor the throttle come
into contact with any obstacle when the engine starts.
IMPORTANT
Avoid pulling the rope to its end or returning it by releasing the knob. Such
actions can cause starter failures.
7. Move the choke lever downward to open the choke.
And restart engine.
(1) Choke lever
(2) Glose
(3) Open
8. Allow the engine to warm up for a severa! minutes before starting opera-
tion.
NOTE
1. When restarting the engine immediately alter stopping it, leave the choke
open.
2. Overchoking can make the engine hard to start due to excess fuel When
the engine failed to start alter several attempts, open the choke and repeat
pulling the rape, or remove the spark plug and dry it.
STOPPING ENGINE
1. Release the throttle lever and run the engine for hall a minute.
2. Shift the stop switch to the STOP position.
IMPORTANT
Except for an emergency, avoid stopping the engine while pulling the thrott-
le lever.
IMPORTANT
When it doesn't stop at the stop switch, move the choke level to the closed
position.
(1) Choke lever
To Next Page
Loading...
