17
ADJUSTING THROTTLIE CABLIE
The normal play is 1 or 2 mm when measured at the carburetor side end.
Readjust with ths cable adjuster as required.
(1) Cable adjuster
ADJUSTING IDLING SPEED
When the engins tsnds to stop frsqusntly at idling mode, turn the adjusting
screw clockwise.
(1) Idle adjusting screw
2. When the cutting hsad keeps rotating aftsr relsasing ths triggsr, turn ths
adjusting screw countsr-clockwise.
NOTE
arm up the engins before adjusting the idling spsed.
WARNING
The cutting head will start rotating upon the engine starts.
1. Feed fuel into the fuel tank and tighten the cap secursly.
Feed the chain oil into the oil tank and tighten ths cap secursly, too.
(1) Fuel
(2) Chain oil
2. Rest the unit on a flat, fírm place. Keep the cutting head off the ground
and clear of surrounding objects, as it will start rotating upan starting of the
engine.
3. Push the primer several times until overflown fuel flows out in the clear
tube.
4. Move the choke lever to the closed position.
(1) Choka lavar
(2) Glose
(3) Open
To Next Page
Loading...
