Daewoo DTD-1300 - Getting Started; Location; Initial Setup

10
1. Getting started: Setting up, Battery, date and time
2. Getting to know the phone: Icons and menu
3. Using the phone: On/O , calls, Volume, mute, Intercom, hands-free, redial,
lock, paging
4. Phonebook: Store, view, edit and delete
5. Handset settings: Ringer volume and melody, language, keybeep, warning
beep
6. Base settings PIN, Dial mode, Recall, default settings, Eco mode
7. Clock & alarm: set date, time, alarm
8. Caller ID and the Calls list
9. Using additional handsets
10. Help
11. General information
1. Getting started
1. 1. Location: Place the base within 1.5 meters of the mains power and phone
sockets. It should be 1 meter away from other appliances to avoid interference.
1. 2. Handset range: The range is 300 meters outdoors when there is a clear
line of sight between the base and handset. Any obstruction between the base
and handset will reduce the range. Indoors the range will normally be up to 50
meters.
1. 3. Signal strength:
The
icon on the handset show if it is in range. When out of range, the icon
 ashes. In a call, a beep will be heard and the line will hang up if out of range.
1. 4. Setting up: The base must be plugged to the mains power at all times. Do
not connect the telephone line cord into the wall socket until the handset is fully
charged. Use only the power adapter and phone line cord supplied.
Connecting the base
1. Plug the phone line cord to the socket marked
under the base.
2. Plug the power adapter connecter into the socket marked on the rear
of the base and plug the other end into the mains power wall socket.
Installing and charging the handset
1. Remove the battery cover insert the 2 x AAA NiMH rechargeable batteries
supplied. Note the ‘+’ and ‘-’ markings and insert in the correct direction.
2. Slide the battery cover into place.
3. The  rst charge should last 24 hours.
4. When the handset is fully charged,
icon will appear steadily on the display.
Plug the phone line cord into the telephone wall socket.
5. Battery Low warning: If “low battery”
icon  ashes on the display and there
is a beep during a call, recharge the handset before using it again..
6. Battery performance: Fully charged batteries should give about 6.5 hours talk
time or 135 hours standby time. After charging the handset for the  rst time,
subsequent charging time is about 6-8 hours a day.
7. Date and time: When subscribed to Caller ID, date and time sets automatically
when the  rst call is received. If there is no Caller ID it can be set manually.
ENG