16
9. 3. De-register a handset: Use one handset to de-register another. The handset
being used cannot de-register itself. Press Menu=> « SETUP » => « DEL HANDSET
» and press Menu. Enter the 4 digit PIN code (default = 0000) and press Menu.
Enter the number that needs to be de-registered.
10. Help
No dial tone: Telephone line and main power is connected properly?.
No display: Batteries are inserted correctly and fully charged? Use only batteries
supplied. Handset is switched on? Press and hold End Call. Reset the base by
removing the batteries and disconnecting the power.
icon ashes: Handset is out of range. Move closer to the base, Make sure that
the handset is registered to the base.
Keypad does not seem to work: Check that the keypad lock is not on.
icon is not scrolling during charge: Adjust the handset slightly on the base.
Clean the charging contacts. Check that the mains power is connected properly
and switched on.
No Caller Display: Check the subscription with the network operator. The caller
may have withheld their number. The record cannot be found in the phonebook.
Cannot register a handset to the base: Up to 5 handsets can be registered to a
base. Check that correct PIN code (default = 0000) has been entered.
Handset does not ring: The handset ringer volume may be set to O .
Base unit does not ring: The base ringer volume may be set to O .
Noise interference on phone or on other electrical equipment nearby: Place the
phone at least one meter away from appliances or any metal obstructions to avoid
any risk of interference.
11. Statement of compliance
Flamagas S.A. hereby declares that the DTD-1300 product complies with the
requisites and basic safety requirements of Directive 1999/5/EC on Radio and
Telecommunications Terminal Equipment.
For a full copy of the statement of compliance please see:
www.electronica amagas.com
ENG
To Next Page
Loading...
