Daewoo DWC-LU1011 - 5. ELECTRONIC FIELD PARTS LIST AND SPECIFICATION; Electronic Parts List

4444
6. Error Display
MESSAGE ERROR CAUSE SOLUTION
IE
WATER
INLET ERROR
The water tap is closed. Open the water tap.
The lter of the valve inlet is clogged. Clean the lter of the valve inlet.
The valve inlet is an inferior product or broke down. Change the valve inlet.
The water level sensor (sensor pressure) is an
inferior product or broke down.
Change the water level sensor
(sensor pressure).
The drain motor works during water supply. Change the drain motor.
The PCB ASS’Y does not check the water level. Change the PCB ASS’Y.
OE
DRAIN
ERROR
The drain hose is kinked or clogged. Clean and straighten the drain hose.
The drain motor is an inferior product. Change the drain motor.
The valve inlet works during drain. Change the valve inlet
The water level sensor is an inferior product . Change the water level sensor.
The PCB ASS’Y does not check the water level. Change the PCB ASS’Y.
UE
UN-BALANCE
ERROR
The laundry is concentrated to one side of the drum
during spin.
Rearrange the laundry.
LE
DOOR
OPEN ERROR
The Start/Hold button is pressed while the door is
opened.
Close the door.
The switch door lock is an inferior product. Change the switch door lock.
The PCB ASS’Y does not check the door lock. Change the PCB ASS’Y.
E1
Water level
detection error
Water level is below reset or overow is detected Change the sensor pressure.
E2
OVER
FLOW ERROR
The water is supplied continuously due to an inferior
valve inlet.
Change the valve inlet.
The valve inlet is normal, but the water level sensor
(sensor pressure) is inferior.
Change the water level sensor
(sensor pressure).
The drain motor dose not work.
(The fan motor is an inferior product or broke down.)
Change the drain motor.
E3
FAN MOTOR
ERROR
The fan motor does not work.
(The fan motor is an inferior product or broke down.)
Change the fan motor.
The PCB ASS’Y does not control the fan motor. Check the connector or change the
PCB ASS’Y .
E4
LEAKAGE
ERROR
Water leaks from the tub or the hose drain. Check the leak of the tub or the hose
drain. Then change the tub or the
hose drain.
The foreign matter is jammed in the drain bellows.
(Non-pump model)
Remove the foreign matter in the
drain bellows.
E5
HIGH
VOLTAGE
ERROR
The laundry is jammed between the gasket and the
drum.
Rearrange the laundry.
The PCB ASS’Y is an inferior product. Change the PCB ASS’Y.
E6 EMG ERROR
The laundry is jammed between the gasket and the
drum.
Rearrange the laundry.
The motor is an inferior product. Change the motor.
The PCB ASS’Y is an inferior product. Change the PCB ASS’Y.