25
2-4. Child Lock
①Press the “TEMP”. and “DRY”button simultaneously during processing.
②Under the Child Lock function, only power button is working.
③During Child Lock function, CHL will be displayed on PCB.
④In orden to unlock Child Lock mode, press "TEMP" and "DRY" simultaneously.
2-5. The sequence of drain
①If the checking time to reset point is below 1 min, the remaining drain time is 30 sec.
②If the checking time to reset point is over 1 min, the remaining drain time is 2 min.
③If the checking time to reset point is over 10 min, OE singal will be appeared on PCB.
④If the temperature is over 50 ℃, the water will be supplied to high water level, then the drain will start.
To Next Page
