To Next PageTo Next PageWhy does my Daewoo DWD-F1021 Washer stop during spinning?
If your Daewoo Washer stops during spinning or the spinning is insufficient, check the following: * Is the filter of the drain pump clogged? * Is the drain pump operating? * Did you use the proper amount of detergent? * Is the drain hose placed higher than 1m above the floor?
What to do if the door on my Daewoo DWD-F1021 won't open?
If your Daewoo washer door won't open, wait two minutes to give the electric locking mechanism time to release for safety reasons.
How to fix a Daewoo Washer that won't drain?
If your Daewoo washer isn't draining water, or is draining slowly, inspect the drain hose for kinks or clogs and clean and straighten it. Also, check the drain filter for clogs and clean it.
What does E8 error mean on my Daewoo DWD-F1021 Washer?
To address the E8 MOTOR ERROR on your Daewoo washer, check the connector of the motor. If the motor does not work, you may need to replace it.
Why is my Daewoo Washer making a thumping sound?
If your Daewoo Washer is making a thumping sound, it's likely due to a heavy wash load, which is usually normal. However, if the sound persists, the washer may be out of balance. Stop the washer and redistribute the wash load.
Why is the wash cycle time delayed on my Daewoo DWD-F1021 Washer?
The washing time may vary by the amount of laundry, water pressure, water temperature and other usage conditions. If the imbalance is detected, the wash time shall be increased.
How to fix E4 LEAKAGE ERROR on Daewoo DWD-F1021 Washer?
To resolve the E4 LEAKAGE ERROR on your Daewoo Washer, check for leaks in the tub or the hose drain. Then change the tub or the hose drain.
How to fix E9 SENSOR PRESSURE ERROR on Daewoo DWD-F1021 Washer?
To resolve the E9 SENSOR PRESSURE ERROR on your Daewoo Washer, you should change the water level sensor.
What does PFE error mean on my Daewoo Washer?
To fix the PFE PUMP FILTER ERROR on your Daewoo washer, clean the drain pump filter. If the drain pump does not work during spin, it may need to be replaced. Also, use the proper amount of detergent and place the drain hose 1m below the floor.
What to do if Daewoo Washer will not drain?
If your Daewoo Washer isn't draining, make sure the drain hose isn't frozen or blocked with dirt. Also, check if the drain hose is kinked or deformed, or if the end of the drain hose is immersed in water. Finally, inspect the drain filter for excessive dirt.
General| Model | DWD-F1021 |
|---|---|
| Brand | Daewoo |
| Tub Material | Stainless Steel |
| Control Type | Electronic |
| Voltage | 220-240 V |
| Frequency | 50 Hz |
| Type | Front Load |
| Dimensions (H x W x D) | 850 x 600 x 550 mm |
| Dimensions (W x D x H) | 600 x 550 x 850 mm |
