To Next PageTo Next PageWhat to do if my Daewoo DWD-F1242 Washer shows UE UNBALANCE ERROR?
To resolve the UE UNBALANCE ERROR on your Daewoo Washer, rearrange the laundry inside the drum. This error typically occurs when the laundry is concentrated on one side during the spin cycle.
Why is my Daewoo Washer oversudsing?
If your Daewoo Washer is producing excessive suds, it may be due to using too much or an unsuitable detergent. Try using a suitable detergent and the correct amount for your load size.
Why is my Daewoo DWD-F1242 making a thumping sound?
If your Daewoo Washer is making a thumping sound, it's likely due to a heavy wash load, which is usually normal. However, if the sound persists, the washer may be out of balance. Stop the washer and redistribute the wash load.
What to do for Daewoo DWD-F1242 IE WATER INLET ERROR?
If you are experiencing the IE WATER INLET ERROR on your Daewoo Washer, make sure the water tap is fully open. Also, check the filter of the valve inlet for any clogs and clean it if necessary. If problems persist you should change the valve inlet, water level sensor or drain motor. Also check the PCB ASS’Y.
How to resolve LE DOOR OPEN ERROR on Daewoo DWD-F1242 Washer?
To resolve the LE DOOR OPEN ERROR on your Daewoo Washer, ensure the door is closed properly. This error can occur if the Start/Hold button is pressed while the door is open. If problems persist you should change the switch door lock or the PCB ASS’Y.
General| Loading Type | Front Loading |
|---|---|
| Maximum Spin Speed | 1200 RPM |
| Noise Level (Washing) | 58 dB |
| Number of Programs | 15 |
| Type | Washer |
| Energy Rating | A |
| Water Consumption | 49 L |
| Dimensions (H x W x D) | 85 cm x 60 cm x 55 cm |
Instructions for removing and managing transit bolts during initial setup of the washer.
Guidelines for proper installation location and electrical safety precautions for UK users.
Step-by-step guide for connecting water inlet and drain hoses to the washing machine.
Steps for disassembling the door lock switch, heater, thermistor, motor, and drain pump.
Provides solutions for common symptoms like noise, leaks, and slow draining.
Lists error messages (IE, OE, UE, etc.) with causes and recommended solutions.
