Daewoo FLR00046 - Using Your Vacuum Cleaner; Adjusting the Floor Tool Lever; Using the Crevice and Upholstery Tool; Using Attachments with Hose

9
Tornado Cylinder 700W Cyclonic Vacuum
Model No.: FLR00046
User Manual
IMPORTANT – RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
Using Your Vacuum Cleaner
1. Fully reel out the Mains Cable and Plug (6) from the vacuum cleaner, being
careful not the pull the cable out beyond the red mark but after the yellow
mark.
2. Insert the mains plug into the nearest socket.
3. Press the On/off button (3) to power up the vacuum.
Adjust the lever on the Floor Tool (12) according to the type of floor being
cleaned. Push the lever down for use on hard floors (i.e. non carpeted), pull the
lever up for vacuum cleaning carpets:
Using the Crevice & Upholstery Multi Tool (13)
Attach the Crevice & Upholstery Multi Tool (13) onto the Telescopic Tube (18) to
clean carpet edges, upholstered furniture and hard to get at areas:
If the Telescopic Tube (18) is not required, attach the Crevice & Upholstery
multi tool (13) or the Floor tool (12) directly to the Tool connector (17), this useful
whilst cleaning soft furnishings, stairs, etc. as below:
Left:
Adjust the lever on the
Floor Tool for carpeted or
hard floors:
Up for carpets
Down for hard floors
Left: Attached the Crevice
& Upholstery multi tool to
clean carpet edges
Right: Fold the brush down
to clean hard to get at
areas and upholstery.
Left: Attached the Crevice
& Upholstery multi tool to
the Hose. Use the brush to
clean upholstery.
Right: Attached the
Floor tool to the Hose to
clean the stairs.