19
Insert a screw driver (flat tip) into a groove of the right wheel
(bottom of refrigerator) and turn it clockwise until the door is balanced.
(clockwise to raise refrigerator door ; counterclockwise to lower)
In case refrigerator door is lower than freezer door...
After installation and/or door leveling, fasten front cover with screws.
(Remove the screws on the front bottom panel first. Click and screw the cover)
Front Cover
Refrigerator Leveling & Door
Adjustment ( If needed. )
Refrigerator must be level in order to maintain optimal performance and desirable front appearance.
(If the floor beneath the refrigerator is uneven, freezer and refrigerator doors look unbalanced.)
Insert a screw driver (flat tip) into a groove of the left wheel
(bottom of freezer) and turn it clockwise until the door is balanced.
(clockwise to raise freezer door ; counterclockwise to lower)
In case freezer door is lower than refrigerator door...
●
The front of refrigerator needs to be higher just a little than the back for
easy door closing, but if the wheel is raised too much for door balance, i.e.
front of refrigerator is higher than the back, it can be difficult to open the
door.
Caution
To Next Page
Loading...
