Daewoo KOR-804M - Page 31

(1)
Remove
the
out
plate
@
and
door
frame
@..
(2) Remove the microwave absorber ® and film @.
(3)
Remove
a
spring
two
hook
pins
a
hook
lever
@
and
two
hooks
®),
©.
(4)
The
door
weld
assembly
@.
(5) Revers the above steps for reassembly.
4.
Method
to
reduce
the
gap
between
the
door
seal
and
the
oven
front
surface.
(1) To reduce gap located on part ‘A’.
1) Loosen two bolts and nuts. On top door
hinge stopper, then push the door to
contact the door seal to oven front
surface.
2) Tighten two bolts and nuts.
(2) To reduce gap located on part ‘B’.
1)
Loosen
two
bolts
and
nuts
on
under
hinge
stoppe,
then
push
the
door
to
contact
the
seal
to
oven front surface.
2) Tighten two bolts and nuts.
(3) To reduce gap located on part ‘C’. (See Fig. A)
1) Remove. the cabinet.
2)
Loosen
a
screw
on
interlock
switch
assembly
located
bottom
of
oven
body.
3)
Draw
the
interlock
switch
assembly
inward
as
possible
to
engage
with
hook
on
the
door
bottom.
4) Tighten a screw.
(4) To reduce gap located on part ‘D’ (See Fig. B)
1) Remove the cabinet.
2)
Loosen
a
screw
on
interlock
switch
assembly
located
top
of
over
body.
3) and (4) are same as step (3).
30