DAF LF45 - Page 55

©
200515 3-9
Inspection and adjustment
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΛΦ45/55 series
5
3. Check/correct the valve clearance of the
specified inlet and exhaust valves. Set the
correct valve clearance by loosening the
locknut and rotating the adjusting screw in
the correct direction; see "Technical data" for
the correct valve clearance.
4. Using an open-end spanner on the fan shaft,
turn the crankshaft one rotation further so
that the mark (A) is once again between the
bolts (B) and the valves of cylinder 6 overlap.
5. Check/correct the valve clearance of the
specified inlet and exhaust valves. Set the
correct valve clearance by loosening the
locknut and rotating the adjusting screw in
the correct direction; see "Technical data" for
the correct valve clearance.
6. Fit the valve cover. See "Removal and
installation".
M201064
Cylinder Inlet valve Exhaust valve
1
2X
3X
4X
5X
6X X
M201065
A
B
B
Cylinder Inlet valve Exhaust valve
1X X
2X
3X
4X
5X
6
https://www.truck-manuals.net/