EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
4-6
©
200515
Removal and installation
5
ΛΦ45/55 series
4.6 REMOVAL AND INSTALLATION, VALVE COVER
When the engine or parts of the
engine are opened, dirt can get in.
This may cause serious damage to
the engine. The engine should
therefore be cleaned thoroughly
before any parts are opened.
Removing the valve cover
1. Clean the area around the valve cover.
2. Remove the banjo bolt and the attachment of
the plastic crankcase breather tube.
3. Remove the valve cover attachment nuts.
4. Remove the valve cover.
Installing the valve cover
1. Clean the sealing surface of the valve sleeve
and the valve cover.
2. Check the valve cover gasket. If the valve
cover gasket is not damaged, it may be re-
used.
3. Fit the valve cover gasket to the valve cover.
4. Fit the valve cover.
5. Fit the valve cover attachment nuts and
tighten them to the specified torque; see
"Technical data".
6. Fit the plastic crankcase breather tube and
the banjo bolt to the valve cover.
Steering g ear and brake syst em
}
https://www.truck-manuals.net/
To Next Page
Loading...
