User's Manual
7
6 Door Detector Configuration
You can view and edit general information of the door detector.
6.1 Configuring the Door Detector
On the
Hub
interface, select the door detector as needed from the accessory list, and then you can
configure the parameters of the door detector.
Table 6-1 Door detector parameter description
Parameter Description
Device Configuration
●
View device name, type, SN and device model.
●
Edit device name, and then tap
Save
to save
configuration.
Area Select the area to which the door detector is assigned.
24 H Protection Zone
The accessory located in the 24 h protection zone is
always active whether the security system is
configured in the armed mode or not.
Home Mode
Enable the home mode, and then the selected
accessories under the hub will be armed.
Delay Mode under Home Mode
Enable the
Delay Mode under Home Mode
, the
selected accessory under the hub will be armed and
the alarm will not be triggered until the end of
customized delay time.
Only enable
Home Mode
first can
Delay Mode under
Home Mode
take effect.
Delay Time
●
The system provides you with time to leave or
enter the armed zone without alarm.
●
Select from 0 s to 120 s.
The arming mode will be effective after the delay time.
External Detector Access Connect the wired peripheral with the cable.
Alarm-speaker Linkage
When an alarm is triggered, the accessories will report
the alarm events to the hub and alert with siren.
Alarm-video Linkage
When an alarm is triggered, the accessories will report
the alarm events to the hub and then will be linked
with videos.
Video Channel Select the video channel as needed.
Signal Strength Detection Test the current signal strength.
Detector Test Detect whether the accessory works.
To Next Page
Loading...
Need help?
General