2 Network Conguration
Device initialization and IP setting can be nished with the CongTool or on webpage. For more
information, see web operation manual.
●
Device initialization is available on select models, and it is required at rst-time use and after
device is reset.
●
Device initialization is available only when the IP addresses of the device (192.168.1.108 by
default) and the computer stays on the same network segment.
●
Plan usable network segment properly to connect the device to the network.
●
The following gures and pages are for reference only.
2.1 Initializing the Camera
Procedure
Step 1 Search for the device that needs to be initialized through CongTool.
a. Double-click CongTool.exe to open the tool.
b. Click Modify IP.
c. Select the searching way, and then click OK.
d. Select one or several cameras in uninitialized status, and then click Initialize.
Step 2 Select the devices to be initialized, and then click Initialize.
If you do not provide the email address for password reset, you can reset the password
only through XML le.
Figure 2-1 Password setting
Step 3 Select Auto-check for updates as needed, and then click OK to initialize the device.
Quick Start Guide
4