●
Use the accessories suggested by the manufacturer. Installation and maintenance must be
performed by qualied professionals.
●
Do not directly touch the photosensitive CMOS. Use an air blower to clean the dust or dirt on
the lens. When it is necessary to clean the device, slightly wet a soft cloth with alcohol, and
gently wipe away the dirt.
●
Clean the device body with a soft dry cloth. If there are any stubborn stains, clean them away
with a soft cloth dipped in a neutral detergent, and then wipe the surface dry. Do not use
volatile solvents such as ethyl alcohol, benzene, diluent, or abrasive detergents on the device to
avoid damaging the coating and degrading the performance of the device.
●
The dome cover is an optical component. When it is contaminated with dust, grease, or
ngerprints, use degreasing cotton moistened with a little ether or a clean soft cloth dipped in
water to gently wipe it clean. An air gun is useful for blowing dust away.
●
It is normal for a camera made of stainless steel to develop rust on its surface after being used in
a strong corrosive environment (such as the seaside, and chemical plants). Use an abrasive soft
cloth moistened with a little acid solution (vinegar is recommended) to gently wipe it away.
Afterwards, wipe it dry.
Quick Start Guide
V
To Next Page
Loading...
Need help?
General
