Dahua Technology DH-XVR4104C-X1 - Page 333

User’s Manual
321
 HDD jumper is damaged.
 HDD is broken.
 Upgraded program is not compatible.
 The recorded file has been overwritten.
 Record function has been disabled.
7. Video is distorted when searching local records.
There are following possibilities:
 Video quality setup is too low.
 Program read error, bit data is too small. There is mosaic in the full screen. Restart the DVR to solve
this problem.
 HDD data jumper error.
 HDD malfunction.
 DVR hardware malfunctions.
8. No audio under monitor state.
There are following possibilities:
 It is not a power picker.
 It is not a power acoustics.
 Audio cable is damaged.
 DVR hardware malfunctions.
9. There is audio under monitor state but no audio under playback state.
There are following possibilities:
 Setup is not correct. Enable audio function.
 Corresponding channel has no video input. Playback is not continuous when the screen is blue.
10. System time is not correct.
There are following possibilities:
 Setup is not correct.
 Battery contact is not correct or voltage is too low.
 Crystal oscillator is broken.
11. Cannot control PTZ on DVR.
There are following possibilities:
 Front panel PTZ error.
 PTZ decoder setup, connection or installation is not correct.
 Cable connection is not correct.
 PTZ setup is not correct.
 PTZ decoder and DVR protocol is not compatible.
 PTZ decoder and DVR address is not compatible.
 When there are several decoders, add 120 Ohm between the PTZ decoder A/B cables furthest end
to delete the reverberation or impedance matching. Otherwise the PTZ control is not stable.
 The distance is too far.
12. Motion detection function does not work.
There are following possibilities:
 Period setup is not correct.
 Motion detection zone setup is not correct.
 Sensitivity is too low.