Local Configurations 170
Select the Send Email check box to enable the system to send an
email notification when an alarm event occurs.
To use this function, make sure the email function is enabled in Main
Menu > NETWORK > EMAIL.
Select the check box to activate a buzzer noise at the Device.
Select the check box to enable the Device to record a local alarm log.
Select to enable audio broadcast/voice prompts in response to a HDD
alarm event.
Table 5-41
Click Apply to complete the settings. Step 3
5.10.5.2 Configuring Network Event Settings
Select Main Menu > ALARM > ABNORMITY > Network. Step 1
The Network interface is displayed. See Figure 5-138.
Figure 5-138
Configure the settings for the Network event. See Table 5-42. Step 2
In the Event Type list, select Net Disconnection, IP Conflicted, or
MAC Conflicted as the event type.
Enable or disable the Network event detection function.
To Next Page
Loading...
